Today may and I sat down to finally get new code implemented in labview. We need the 3 motors that we use to remember their position that they were in even if we cycle the power, so it can home seek at the end of all of its routines. We ended up spending a couple hours trying to get the registry working in the motors original test code. The offsets for the motors needed to be reset, but after a while of working through the program we figured out a way for the program to select the angle measure we wanted from the long line of data.
After lunch I ordered a new dongle it cost a whole $95 freakin dollars, holy crap what a rip off, its just a piece of plastic with a simple circuit board inside!!!!!!!!!! All they r good for is breaking!!!!!!! Then we heard a large clatter from roof, we went up to the roof, it was santa clause, just kidding it was the thunderbirds, gosh your so gullible
No comments:
Post a Comment